{"conflicts": [{"conflict_id": "ibc_version_discrepancy", "category": "note_or_spec_contradiction", "severity": "high", "confidence": "high", "location": "Project-wide Codes & Standards", "disciplines": ["General", "Architectural", "Electrical"], "sheets": ["G21.01", "A23.01", "E01.01"], "description": "The drawing set lists conflicting editions of the International Building Code (IBC). The Code / Exiting Plan sheet G21.01 lists the 2018 IBC as the governing code. However, the Architectural Finish Plan A23.01 references the 2021 IBC for finish compliance, and the Electrical Notes sheet E01.01 also references the 2021 IBC. The entire basis of design and permitting relies on a single, correct code edition. This must be resolved before issuance.", "evidence": [{"discipline": "General", "sheet": "G21.01", "source_text": "2018 INTERNATIONAL BUILDING CODE (IBC) CH. 2-10 WITH HARRIS COUNTY AMENDMENTS", "asserted_value": "2018 IBC"}, {"discipline": "Architectural", "sheet": "A23.01", "source_text": "INTERIOR FINISHES TO COMPLY WITH IBC CLASS C OR HIGHER SECTION 803.9 AND TABLE 803.9 OF 2021 IBC.", "asserted_value": "2021 IBC"}, {"discipline": "Electrical", "sheet": "E01.01", "source_text": "CONTRACTOR SHALL CONFORM TO ALL LOCAL, STATE, AND APPLICABLE CODES, 2023 NEC, 2021 IBC, 2021 IECC, NFPA, ETC.", "asserted_value": "2021 IBC"}], "recommended_resolution": "verify with architect"}, {"conflict_id": "nec_version_discrepancy", "category": "note_or_spec_contradiction", "severity": "high", "confidence": "high", "location": "Project-wide Codes & Standards", "disciplines": ["General", "Electrical"], "sheets": ["G21.01", "E01.01"], "description": "There is a conflicting and confusing reference to the applicable National Electrical Code (NEC). The general Code/Exiting Plan sheet G21.01 states '2023 STATE OF TEXAS ADOPTED 2014 NFPA 70 NATIONAL ELECTRICAL CODE (NEC)', while the electrical notes on sheet E01.01 simply state '2023 NEC'. This creates ambiguity as to whether the 2014 or 2023 edition of the NEC should be followed. This must be clarified and made consistent.", "evidence": [{"discipline": "General", "sheet": "G21.01", "source_text": "2023 STATE OF TEXAS ADOPTED 2014 NFPA 70 NATIONAL ELECTRICAL CODE (NEC)", "asserted_value": "2014 NEC (part of a 2023 Texas adoption)"}, {"discipline": "Electrical", "sheet": "E01.01", "source_text": "CONTRACTOR SHALL CONFORM TO ALL LOCAL, STATE, AND APPLICABLE CODES, 2023 NEC, 2021 IBC, 2021 IECC, NFPA, ETC.", "asserted_value": "2023 NEC"}], "recommended_resolution": "verify with engineer"}]}